Publicité
Les langues disponibles
Les langues disponibles
7
DISASSEMBLY AND STORAGE
Drain, clean, disassemble and properly store the spa set and related
components indoors when the temperature drops below 39°F (4°C).
WARNING
Always unplug this product from the power supply before removing,
cleaning, servicing or making any adjustment to the product.
Draining the SPA
1. Unplug the control box from the power supply.
2. Remove the cap on the drainage outlet on the external wall of the
SPA(below the One-way Valve(E)).
3. Install the Drainage Regulator(O) onto the Inflation Hose(G). Then
attach to the drainage outlet.
4. Point the inflation hose towards a suitable draining area.
5. Remove the Bottom plug(H) to drain the water.
6. When there is no more water in the pool, power on and press the
BUBBLE button for 2–3 minutes to discharge residual liquid from the
air hose.
7. When the water has completely drained away, remove the
inflation hose and shut both outlets again.
CAUTION
The drained water can contain chemical residues and/or other
unhygienic components, that can have a negative impact on health
and the environment.
Check your local authority regulations to find out how you can safely
and responsibly dispose of the waste water. In order to prevent
unwanted bacterial growth, make sure there is no water or moisture
in the spa.
28
Deflate the SPA
Deflate the Spa Tub Wall: For storage purpose, unscrew the One
Way Valve Kit(E) counter-clockwise to let the air out (If to let go
certain amount of air in use or after inflation, just remove the Air
inlet(Black) on the One Way Valve Kit(E) counter-clockwise to let the
air out.) Once deflation is done, replace the air valve cap back onto
the SPA tub wall.
Deflate the SPA Cover Air Bladder: Pull valve cap out and squeeze
the valve at its base until deflated. Then close and recess the valve
back.
Make sure all the spa components and accessories are thoroughly
clean and dry before storage. Air-dry the spa tub in the sun for an
hour before folding.
Fold the spa tub liner loosely and avoid any sharp corners to prevent
damage or leakage to the spa tub liner. Place it back into the storage
bag provided.
Store the spa tub and accessories indoors, temperature controlled,
between 32º – 104ºF (0º – 40ºC ) The original packing can be used
for storage.
8
TROUBLESHOOTING
Problem
Possible cause
Solution
Check for power failure and check if the spa is
Power failure.
plugged in properly(requires a power source
rated 110~120V, 60Hz, single phase).
The
This product requires 12 amps of electric
control
current.
Household circuit
panel
We recommend a separate circuit for the SPA
does not
breaker tripped.
only, and make sure it's at least 15 amps.
light or
Otherwise, the circuit may be tripped due to
display.
overloading.
GFCI Tripped.
Test and reset the GFCI, refer to GFCI test.
GFCI Plug broken.
Contact our customer service.
29
Publicité
