Publicité
Les langues disponibles
Les langues disponibles
Note: After the heating system turned off automatically or
manually, the filtration system will continue to work for 2
minutes(FILTER icon flashes).
WARNING: Never operate the heating system while the
spa is empty as this may damage the system.
WARNING: Never operate the heating system when the
water frozen in the spa tub.
IMPORTANT: The following conditions will lead to slow
water heating.
• The ambient temperature is lower than 50ºF(10ºC).
• Outdoor wind speed is above 3.5-5.4 m/s(8-12 mph).
• The air bubble function is activated when heating the spa
water.
• The spa is not properly covered with the spa cover when
the water is heating.
FILTER
Press this button to turn the filter pump on and off.
Note: If the heating system is activated, the filtration
system will automatically start.
WARNING: Check if the filter cartridges are installed
properly before start filtration.
Note: After the heating system turned off automatically or
manually, the filtration system will continue to work for 2
minutes.
Note: In HL mode(see ALARM CODE at the end of the
Spa Control Panel section ), press the FILTER button for 5
seconds to start forced filtration.
BUBBLE
Press this button to activate the air bubble system(The
BUBBLE icon lights). The air bubble system is designed
with a 20-minute auto shutoff feature. Wait for 10 minutes,
after the 20 minute bubbling if you would like to restart the
bubbling again.
CAUTION: Do not run bubble system when the cover is
attached, air can accumulate inside the spa and cause
irreparable damage and bodily harm.
22
ALARM CODE - FP
F
C
It means the control base entered the Freeze Protection
(FP)mode.
How to enter the FP mode: set the temperature to 68℉,
press the TEMP DOWN button one more time to enter the
freeze protection mode(FP mode).
In the FP mode, all the other icons are unavailable except
the LOCK, TEMP UP and TEMP DOWN. And the water
will be heated to keep the temperature between 41℉(5℃)
and 50℉(10℃).
How to quit FP mode: Press the TEMP UP button until the
LED screen reads 68℉(20℃).
Note: The FP function works when the water temperature
goes below 41℉(5℃) but over 32℉(0℃).
WARNING: DO NOT use the spa when the ambient
temperature is 39.2℉(4℃）or below. The water
temperature might drops below 0℃, in which case the
internal pipes of the control box will freeze.
ALARM CODE - FC
F
C
When the filtering time reaches 168 hours on aggregate,
the FC code flashes on the display panel. At this time, the
filter pump will continue to work, but the filter cartridge
need to be replaced immediately(unplug from the power
supply).
In the FC alarm state, except for the FILTER button, others
are all unavailable.
Change the filter cartridge, power on then press the
FILTER button to clear the FC alarm. The filter using time
will start calculating again.
23
Publicité
