MIRKA PROS Serie Instructions D'utilisation page 60

en (original)
Replacing the backing pad
Insert the pad wrench between the backing pad and brake seal to hold the spindle nut.
1.
Turn the backing pad counterclockwise to remove it.
2.
3. Fit and tighten the new backing pad with washers.
4. Remove the pad wrench.
Pad saver
Mirka pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and continuously
with net products. These cost effective pad savers, placed between the backing pad and the sanding disc, should be
changed regularly. The pad savers prolong the life of the backing pad.
Replacing the brake seal
1. Remove the backing pad as described above.
Pull the old brake seal out of its groove.
2.
Fit the new brake seal in the groove.
3.
4. Fit the backing pad as described above.
5. Check the brake seal function. By changing the number of washers between the spindle and backing pad, the
effect of the brake seal can be adjusted.
Replacing the muffler kit
PROS NV/CV
Lift up the cover.
Remove the muffler cup by pushing it firmly to the side and insert a screwdriver between the cup and the hex nut, twist
the screwdriver to release the cup from the housing.
Reattach new muffler to the housing.
Reducing vibration when sanding with pad saver or interface
The level of vibration may increase when sanding with a pad saver or interface. Your Mirka tool has a feature to reduce
this vibration. To use this feature, please follow these steps:
1. Disconnect power cable.
Remove backing pad.
2.
Add hex nuts and screws in accordance with the table below, tighten to 2 Nm.
3.
60
Mirka® PROS 150 mm (6"), 125 mm (5")