MIRKA PROS Serie Instructions D'utilisation page 57

Safety Code for Portable Air Tools, ANSI B186.1 available from: American National Standards Institute, Inc.; 1430 Broadway;
New York, New York 10018
State and local regulations
WARNING
Always wear required personal safety protection in accordance with manufacturer s instructions and local/national
standards while using this tool.
Do not use a power tool if you are tired or under the influence of drugs, alcohol or medication.
Read the Materials Safety Data Sheet (MSDS) for the working surface.
Use the tool with dust extraction. A suitable dust extraction unit will reduce hazardous dust.
Do not overreach. Keep proper footing and balance at all times.
Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts.
Loose clothes, jewellery or long hair can be caught in moving parts.
If any physical hand/wrist discomfort is experienced, stop working and seek medical attention.
Hand, wrist and arm injury may result from repetitive work, motion and overexposure to vibrations.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
The tool is not electrically insulated. Check work area for live electricity, gas pipes, etc. before operation.
CAUTION
Prevent unintentional starting.
Remove pad wrench before connecting the tool to the air supply.
Keep work area clean and well lit.
Always ensure that the work piece to be sanded is firmly fixed.
Before changing abrasive always disconnect the air supply.
Additional Safety Warnings
Read all instructions before using this tool. All operators must be fully trained in usage and safety of this tool.
All maintenance must be carried out by trained personnel. For service, contact Mirka authorized service centre!
Always wear required safety equipment (see warnings).
The operator must be in a secure position and have a firm grip and footing on a solid floor.
Always ensure that the work piece to be sanded is firmly fixed.
Check tool, backing pad, hose and fittings regularly for wear.
Always take care to ensure your safety at work; never carry, store or leave the tool unattended with the air supply
connected.
Vacuum unit dust collection bag should be cleaned or replaced daily. Dust can be highly combustible. Cleaning or
replacing of bag also assures optimum performance.
Do not exceed maximum recommended air pressure of 6.2 bar (90 psig).
Take care to avoid entanglement of the moving parts of the tool with clothing, ties, hair, cleaning rags, etc.
Keep hands clear of the spinning pad during use.
If the tool appears to malfunction, remove from use immediately and arrange for service and repair.
Before changing abrasive always disconnect the air supply. Take care to properly attach and centre the abrasive on the
backing pad.
Technical data
PROS 525NV
Orbit 2.5 mm (3/32")
Vacuum type Non
Pad size Ø 125 mm (5")
Product net weight 0.89 kg (2.0 lbs)
Height 102 mm (4")
550CV/NV 580CV/NV
5 mm (3/16") 8 mm (5/16")
Central Central
Ø 125 mm (5") Ø 125 mm (5")
0.89 kg (2.0 lbs) 0.91 kg (2.0 lbs)
102 mm (4") 102 mm (4")
625CV/NV 650CV/NV
2.5 mm (3/32") 5 mm (3/16")
Central Central
Ø 150 mm (6") Ø 150 mm (6")
0.9 kg (2.0 lbs) 0.93 kg (2.1 lbs)
102 mm (4") 102 mm (4")
Mirka® PROS 150 mm (6"), 125 mm (5")
en (original)
680CV/NV
8 mm (5/16")
Central
Ø 150 mm (6")
0.95 kg (2.1 lbs)
102 mm (4")
57