Parkside PWD 12 B1 Traduction Des Instructions D'origine page 29

Cleaning
NOTICE! Risk of damage! Improper
cleaning can damage the device. Nev-
er spray down the device with water. Do
not use any abrasive cleaning agents or
solvents.
Emptying the dirt container
1. Mount the motor head.
Place the motor head (1) with the top
facing downward.
2. Empty the dirt container.
3. Mount the motor head.
General cleaning
1. Clean the dirt container (6) with a
damp cloth.
2. Wash the foam filter (15) with warm
water and soap and let it dry.
3. Tap out the contents of the textile filter
(16). If needed, wash it with warm wa-
ter and soap and let it dry.
4. When full, replace the paper filter bag
(17) (for reordering, see Spare parts
and accessories, p. 32).
Maintenance
The device is maintenance free.
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• out of the reach of children
Notes
• The dirt container is not suitable for
Preparing the device for storage
(Fig. F)
1. Wind the power cord (10) around the
2. Insert the disassembled suction pipes
3. Wind the suction hose (13) around
4. Insert the nozzles into the accessory
Possible cause
On/Off switch (3) turned off Check the position of the
No mains power supply
On/Off switch (3) is broken
Worn out carbon brushes
Defective motor
storing liquids. Empty the dirt container
after wet vacuuming.
holders (24). Fix the power cable us-
ing the cable clip (11).
(12) into the accessory holders on the
feet (7).
the device and plug the handle section
(14) into a suction pipe (12).
holders (4) on the motor head.
Error correction
On/Off switch
Check the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
contact the service centre.
GB MT
29