Télécharger Imprimer la page

Parkside PWD 12 B1 Traduction Des Instructions D'origine page 28

Masquer les pouces Voir aussi pour PWD 12 B1:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
GB
MT
Vacuuming fine dust
Notes
• Never perform vacuuming without a fil-
ter!
• To vacuum fine dust, you will need an
additional fine dust filter bag (Spare
parts and accessories, p. 32).
Permitted filters and nozzles
• Filter
• Textile filter (16)
• Filter bag
• Fine dust filter bag
• Nozzles
• All
Wet vacuuming
Notes
• Never perform vacuuming without a fil-
ter!
• When wet vacuuming, a float interrupts
the suction air flow when the dirt con-
tainer is full. Switch the appliance off
and empty the dirt container.
• The dirt container is not suitable for
storing liquids. Empty the dirt container
after wet vacuuming.
• When wet vacuuming, make sure that
the vacuum cleaner is always higher
than the water surface to be vacuumed.
Otherwise, negative pressure/suction
(siphon effect) could occur.
Permitted filters and nozzles
• Filter
Foam filter (15)
• Filter bag
without
• Nozzles
All
28
Blowing
Preparing the blowing function
(Fig. C)
1. Remove the filter and filter bag.
See Attaching and removing the filter
and filter bag, p. 26.
2. Push the suction hose (13) into the
blower connector (9).
See Attaching and removing the suc-
tion hose, p. 26.
Switching on and off
Preparation
1. Prepare the device for the desired func-
tion.
2. Fully unwind the suction hose (13).
3. Insert the machine plug into a wall
socket.
Switching on
1. Move the On/Off switch (3) to the po-
sition "I" (ON).
Switching off
1. Move the On/Off switch (3) to the po-
sition "0" (OFF).
2. Pull the device plug out of the wall
socket if you are leaving the device un-
attended or if you have finished work-
ing.
Cleaning, maintenance
and storage
 WARNING! Electric shock! Risk of in-
jury due to unintentional start-up. Protect
yourself when performing maintenance or
cleaning work. Switch off the device and
disconnect the mains plug from the socket.
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.

Publicité

loading