Gaggenau 400 Serie Instructions D'installation page 9

4.2 Attach Power Cord
Plug the end of the supply cord into the back of the
▶
dishwasher.
Be sure to push it all the way in until fully seated.
‒
The outlet for the power supply cord should be located
in a cabinet or wall adjacent to the dishwasher cabinet.
Do not plug dishwasher into the wall outlet until all the
steps of the installation are complete.
Notes
If you require a permanent wiring connection, order kit
¡
junction box accessory kit SMZPCJB1UC.
If local electrical codes require clips to secure the power
¡
cord wire to the dishwasher, use accessory kit
SMZEPCC1UC.
4.3 Mounting Brackets Vario Hinge
Before installing the supplied mounting brackets, decide
which method of securing the dishwasher into its
enclosure will be used, top (wood or porous material) or
side (stone or solid surface). Once the mounting brackets
are installed on the dishwasher, removing them is difficult
and will damage the mounting brackets and the
dishwasher. If you have a Fully Integrated Panel, do not
attach mounting brackets until after attaching the panel to
the door.
WARNING
Avoid tip over hazard
Do not use the dishwasher until it is completely
▶
installed. When opening the door on an uninstalled
dishwasher, carefully open the door while supporting
the rear of the unit. Failure to follow this warning can
result in serious injury.
Top and Side Mount
For openings wider than 23 5/8" (600 mm), use the metal
mounting brackets. Top mount is for wood or other
materials that can easily be drilled into. Side mount is for
stone countertops or another hard material that cannot
easily be drilled. Both use the same mounting brackets,
but the difference is the screw placement.
Orient the mounting brackets as shown and position the
▶
tabs into openings on the dishwasher's front corners.
For side mount, bend the brackets down at the
‒
perforation.
Side Mount Force Distributor
The side mount force distributors are for cabinet openings
that are 23 5/8".
Insert a side mount force distributor into the opening in
▶
each side. Make sure it is flush with the dishwasher.
4.4 Attaching the Apron
Remove tape covering adhesive strip on the rubber
1.
apron.
Installation Procedure en-us
9