Gaggenau 400 Serie Instructions D'installation page 17

Properly tighten all water connections.
3.
After all connections are made, turn on the hot water
4.
and check for leaks.
5.2 Installing the Drain Connection
The drain hose must be installed with either a high loop or
an air gap.
NOTICE:
Proper drain hose installation
The dishwasher drain hose must be installed with a
▶
portion of it at least 33" (84 cm) off the floor; otherwise
the dishwasher may not drain properly.
Remove garbage disposal plug
If the dishwasher drain hose will be connected to a
▶
garbage disposal connection, first remove the plug from
the disposal connection.
Note
Important notes for drain connection:
If local ordinance require an air gap, install it according
¡
to the manufacturer's instructions.
The drain hose length can be extended if necessary.
¡
Use kit #SGZ1010UC. The maximum length of the drain
hose, including the hose leading to the air gap, is 150"
(380 cm).
You may attach the hose clip to the inside of the
¡
adjacent cabinet to hang the drain hose (screws are not
supplied) in place of using a nonmetallic tie as pictured
in the next illustrations. Do not exceed 43" in drain hose
height.
Place hose clamp around end of drain hose BEFORE
1.
connecting to the plumbing.
If you have a garbage disposal, connect the drain hose
2.
to the garbage disposal with either a high loop or an air
gap.
If you do not have a garbage disposal, connect the
3.
drain hose to the drain connection with either a high
loop or an air gap.
Insert the included drain hose adaptor before
4.
connecting to the plumbing.
Tighten the hose clamp around the house plumbing.
5.
Dishwasher Connection en-us
17