Gaggenau 400 Serie Instructions D'installation page 6

en-us Before you begin
Parts
Shut-off valve and fittings
appropriate for hot water supply
line.
6
Flat screwdriver
Adjustable wrench
Level
T-15 Star-head
screwdriver
T-20 Star-head
screwdriver
Jigsaw
Pencil
Steel Square
Center Punch
2.4 Pre-install Checklist
Ensure that the following requirements are met when
planning the installation of your appliance.
WARNING
Avoid Scalding or Electric Shock Hazard
Make sure the water supply and electrical supply are
▶
shut off before installation or service.
Do not allow the electrical and supply lines to touch.
▶
Select a location as close to the sink as possible for
¡
easy access to water supply and drain lines.
Be sure the unit is installed close enough to the sink so
¡
the drain hose length does not exceed 92" (2337 mm)
and so that a portion of the drain hose is raised at least
33" above the floor level.
Ensure that the enclosure is square and the opening is
¡
at least 32 1/8" (817 mm) high and 23 5/8" (600 mm)
wide.
Check that the opening in the cabinet is large enough
¡
for routing the electric cable, water line, and drain hose,
and if not, create a new opening. See
→ "Installation Preparation", Page 7
If the opening is wood, be sure it is sanded smooth. If it
¡
is metal, be sure it is covered by a protective gasket.
Be sure that your water heater set at 120° F (49° C)
¡
and the water pressure measures at 15-145 psi (1-10
bar)
Determine the mounting method based on the
¡
dishwasher model and counter-top type. See .
Only use the included hardware for the installation. If
¡
you are replacing a dishwasher, dispose of old hose
and other equipment properly.
To avoid scratching the floor, have floor protection
¡
ready for when the dishwasher will be slid into the
cabinet.
2.5 Electrical Requirements
Ensure that the following electrical requirements are met.
Dishwasher electrical rating
Volts
Hertz
Amperes
Watts
Electrical Supply
The customer has the responsibility of ensuring that the
dishwasher electrical installation is in compliance with all
national and local electrical codes and ordinances. The
dishwasher is designed for an electrical supply of 120V,
60 Hz, AC, connected to a dishwasher-dedicated, properly
grounded electrical circuit with a fuse or breaker rated 15
or 20 amps.
120
60
12
1,440 (max)