Gaggenau 400 Serie Instructions D'installation page 16

en-us Dishwasher Connection
Mark the correct position, then slide the brackets out
3.
and bend out the metal tab at the correct position.
Bending a tab ensures that the toe panel cannot slide in
further.
Re-insert the brackets.
4.
Secure the outer toe panel with the crosshead screws
5.
provided.
The outer toe panel should completely cover the
‒
rubber apron.
To cover the screw heads, use the black plastic caps.
6.
Dishwasher Connection 5 Dishwasher Connection
Follow these instructions to connect the dishwasher.
Dishwasher Connection
5.1 Installing the Water Inlet Connection
The hot water heater should be set to deliver
approximately 120 °F (49 °C) [max. 140 °F/ (60 °C)]
water to the dishwasher. Water that is too hot can cause
16
some detergents to lose effectiveness. Lower water
temperatures will increase run times. The hot water supply
pressure must be between 7.25 - 145 psi (0.5 - 10 bar).
WARNING
Scalding Hazard
Do not perform any work on a pressured hot water line.
▶
Serious injury could result. Only qualified plumbers
should perform plumbing work. Do not attempt any work
on the dishwasher hot water supply plumbing until you
are certain the hot water supply is shut off.
NOTICE:
Soldering plumbing lines
Temperatures required for soldering and sweating will
▶
damage the dishwasher. If plumbing lines are to be
soldered or sweated, keep the heat source at least 6
inches (152.4 mm) away from the dishwasher.
Plumbing codes
Check local plumbing codes for approved plumbing
▶
procedures and accessories. All plumbing should be
done in accordance with national and local codes.
Note
Important notes for water connection:
If using a solder joint instead of a compression fitting,
¡
be sure to complete all solder connections before
connecting the water supply line to the dishwasher.
Use an approved dishwasher water supply line with the
¡
correct fittings for this connection.
If using copper tubing or other material not depicted in
¡
this manual for water supply, defer to a licensed
plumber for proper installation.
Always use appropriate seals when making plumbing
¡
connections.
Flush the incoming water line for approximately 1
1.
minute to clear any foreign material.
Connect the dishwasher water supply line to the water
2.
shut off valve, using the adaptor if included with your
model.
Install a shut off valve if one isn't already in the
‒
supply line.
Make sure there are no sharp bends or kinks in the
‒
water line that might restrict water flow.