Problems - SCHOLTES SOTG1630B Manuel D'utilisation

5. PROBLEMS

LIGHTING BURNERS
Lighting burners: there are
no sparks when I push down
on the knob
When i press a knob, there are
sparks on all burners at once
There are sparks but the
burners do not light.
When lighting, flames ignite
but go out when the knob is
released
In the low position, the
burner goes out or flames
remain too high.
The flames have an
irregular appearance.
Knobs become hot during
cooking.
SOLUTION
Check that your hob is electrically connected.
Check that the igniters are clean.
Check that burners are clean and properly assembled.
If the hob is fixed to the worktop, make sure that the
fixing clamps have not been twisted.
Check that the sealing washers under the knobs have
not come out of their locations.
This is normal. The lighting system is centralised and
all the burners spark at the same time.
Check that the gas inlet is open.
If you use gas tanks or cylinders check that they are
not empty .
If you have just installed your hob or changed a
gas cylinder, keep the knob fully pressed for a few
seconds to allow gas to arrive at the burners.
Make sure the lid is properly positioned
Press the knobs as far as they will go and maintain the
pressure for several seconds after flames appear.
Check that the burner components are correctly
positioned.
Check that the sealing washers under the knobs have
not come out of their locations.
Avoid strong draughts in the room.
Light the burner before placing a pan on it.
Avoid strong draughts in the room.
Check that the injectors fitted are the right ones
for the gas being used (see the identification on the
injectors in the «Changing gas type» section).
Reminder: Remember that gas hobs are delivered set
up for use with mains gas (natural gas).
Check that the retarder screws are properly adjusted
(see «Changing gas type» paragraph).
Check that the burners and injectors underneath them,
burner assemblies are clean, etc...
Use smaller pans on the burners close to the knobs.
36