Changing The Type Of Gas - SCHOLTES SOTG1630B Manuel D'utilisation

(LPG) the use of pressure regulator is allowed only if they are in compliance with UNI
EN 12864. The adjustable connection is fixed to the comprehensive ramp by means
of a threaded nut G 1/2». Screw the parts without force, adjust the connection in the
necessary direction and tighten everything (fig. 7).
The appliance must be connected to the gas system by means of stiff metal pipes or
flexible steel pipes having continuous walls, in compliance with the regulations in force.
Rigid connection: Carry out connection by using metal rigid pipes (copper with
mechanical end) (UNI-CIG 7129).
Flexible connection: Use a flexible pipe in stainless steel (UNI-CIG 9891) with a
maximum length 2m.
When installation is complete, make sure that the seal of each pipe fitting is correct.
Use a soapy solution, not a flame.

2.4 Changing the type of gas

Replacing the nozzles
Note: Your appliance is supplied ready for use with natural gas. The
injectors required for adapting it to butane/propane can be found in the
plastic bag containing this guide.
Whenever you change the gas type, you must follow these steps in turn:
1. Change the gas connection
2. Change the nozzles
3. Adjust the retarder on the taps
To change the nozzles remove the racks and burners.
By means of a straight spanner L, unscrew the nozzle U (fig. 7) and substitute it with
the corresponding one: tighten the nozzle strongly.
Set the retarders on the taps : They are located under the knob.
Some models are equipped with both
cylindrical A and conical B connectors for
gas supply. Please select the type which
is correct for the supply concerned. The
connection must not stress the gas ramp.
Once the installation is over, check the
connection seal with a soapy solution.
33