Electrical Connection; Gas Connection - SCHOLTES SOTG1630B Manuel D'utilisation

you use the holes provided for the purpose, as per the drawing.
Connect your hob to the gas (see «Gas connection» section) and to the electricity (see
« Electrical connection » section).

2.2 Electrical connection

Your hob is supplied with a H05RR-F- T90 3-core (phase, neutral + earth) mains
cable, section 0,75 mm ²) and must be connected to a 220-240 V
mains supply via a phase, neutral +earth socket meeting standard IEC 60083 or
an omnipolar isolator with a contact air gap of at least 3.5 mm. The plug must be
accessible after the hob is installed.
CROSS SECTION OF THE CABLE TO BE USED
Cable H05RR-F-T90
Cross section of conductors in mm
WARNING: The protective conductor (green/yellow) is connected to the earth
terminal
earth terminal (Fig. 10).
If the supply cable is damaged, it must be replaced by a cable or special set
available from the manufacturer or its after-sales department.
WARNING: The electrical connection of the cooking hob and the oven must
be carried out separately for security issues and to allow easy removal of
the oven from the unit.

2.3 Gas connection

WARNING: No flexible hoses with a limited service life may be longer than 2
meters and must be accessible for inspection along their entire length. They
must be replaced before their expiry date (printed on the hose). Whatever
means of connection is chosen, make sure that it is gastight when installed,
using soapy-water. In France, you must use a hose or pipe stamped NF Gaz.
The gas connection must comply with the regulations in force in the country where it
is installed.
Make sure that the appliance is adjusted for the gas type available (see the label
under the appliance). If necessary follow the instructions indicated in the chapter "gas
transformations and adjustments" for the possible adaptation to different gases.
If the supplied pressure has not the specified value, it is necessary to assemble a
proper pressure regulator in compliance with the standard UNI EN 88.For Liquid Gas
2
on the hob and must also be connected to the installation's
~
220-240 V - 50 HZ gas
Two conductors, one of which is an earth
0,75
32
~
single phase