Installation; Fitting - SCHOLTES SOTG1630B Manuel D'utilisation

2. INSTALLATION

2.1 Fitting

This worktop must be at least 3 cm thick and heat resistant or else coated with a heat
resistant material.
Any possible wall unit over the cook-top must be placed at a distance of at least 760 mm
from the top. It is advisable to isolate the appliance from the piece of furniture below with a
separator, leaving a depression space of at least 20 mm (Fig. 4).
Make a hole in the worktop according to the dimensions as shown in the figures (Fig.3) with
a minimum distance of at least 100 mm from the edge of the adjacent walls and of at least
50 mm from the appliance border to the back wall.
MODELE
60-75
If the hob is going to be installed on the top of an oven, precautions must be taken to
guarantee an installation in accordance with current accident prevention standards.
If the hob is to be installed above an oven or if other nearby heating appliances could heat
and damage the gas hose, then it is essential that a rigid pipe is installed instead. If a flexible
hose is used (as is the case of butane gas) then it must not be installed in a place where it
may be in contact with a moving part of the kitchen unit or a location likely to get cluttered.
If the hob is going to be installed on the top of a built in oven without forced cooling
ventilation, proper air vents must be installed to guarantee an adequate ventilation, with the
lower air entering with a cross section of at least 200cm2, and the higher air exiting with a
cross section of at least 60 cm2.
Under no circumstances keep any sprays or pressurized containers in any compartment
below the hob (see «Safety guidelines" chapter).
Remove the « pan supports », burner caps and burner heads, noting their original positions.
Turn the hob upside down and place it carefully over the top of the base unit, so as not to
damage the knobs or igniters.
To ensure a good seal between the body of the hob and the worktop, stick the foam seal S
around the edge of the body, before installing the hob (Fig. 5).
Place the hob over the opening in the base unit, taking care to pull the hob towards you.
Fit the burner heads, caps and pan supports.
If you wish, you can secure the hob in position, using the four fixing clam C and screws
supplied supplied (Fig.6) fixing them to the four corners of the housing. It is essential that
L (mm)
560
31
D (mm)
480