Gas Properties; Use - SCHOLTES SOTG1630B Manuel D'utilisation

Adjust each tap in turn. Remove the knobs and sealing washers by pulling them upwards.
Insert a flat-tipped screwdriver into the hole (F) in the control panel and turn the by-
pass screw F (Fig. 8/8-A), and, for correct minimum setting, turn the screw clockwise.
As regards G30 gas burners, the by-pass screw must be tightened completely. The
setting of the minimum must always be correct, and the flame must always remain on
even if the position is changed from maximum to minimum.

2.5 Gas properties

The table (T) shows the installation of the injectors on your appliance depending on
the gas used. Each number is marked on the injector.

3. USE

Switching on the gas: ach burner is controlled by a tap fitted with a safety system
which, if the flame accidentally goes out (spills, draughts, etc.) the gas inlet is quickly
and automatically switched off and gas is prevented from escaping. Each burner is
supplied from a tap, which is opened by pressing and turning the knob anti-clockwise.
The "O" point corresponds to the tap being off. (Fig. 1)
Choose the desired burner by using the symbols located near the knobs.
To light a burner press the knob and turn fully anti-clockwise to the maximum position.
Holding the knob pressed will cause a series of sparks until the gas lights.
Adjust the setting by turning to flames symbol.
Note: Hold the knob pushed in fully for a few seconds after the flame appears, so as
to trigger the safety system. Adjust the ring of flames so that it does not overflow the
edge of the pan. Do not use a pan with a concave or convex bottom. Do not use pans
that partly cover the knobs. Do not leave the gas on under an empty pan.
Pots
PAN DIAMETER
22 to 24 cm
20 to 22 cm
16 to 20 cm
10 to 14 cm
BURNER
Triple crown
Rapid
Semi-rapid
Auxilary
34
USE
Frying – Boiling
Stearing foods
Sauce - Re-heating
Simmering