(existing) wired switch
You can also control the ventilation unit via a wired switch. When the switch is
operated, the ventilation unit always adjusts the flow rate instantaneously. You
can still use the RF switches to switch back to a lower or higher setting.
However, the mechanical switch will no longer indicate the correct setting.
Motion sensor PIR
The motion sensor detects movement close to the sensor. If motion is
detected, the motion sensor communicates with the ventilation unit via wire-
free communication (RF). The ventilation unit will activate ventilation mode
medium. If a higher ventilation setting was already active, it will be
maintained.
User interface (UI) settings
In standby mode, no LEDs are lit. If the control zone is operated for 10
seconds while the status LED is off, status LED flashes between blue and
green to indicate that the menu for user interface (UI) settings can be
entered. Releasing the control zone now opens the menu.
Standby user interface (UI)
The settings menu can be used to configure the time switch. When the user
interface (UI) settings menu is opened, the current status of the time switch
is indicated by the 5 LEDs. Each time the control zone is operated, the next
position of the time switch is selected. If the control zone is not touched for
at least 10 seconds, it automatically
the standby user interface (UI) is activated. When the user interface (UI)
menu is exited, the selected time switch position is used and saved.
The time switch can be used to switch on a lamp. For example, if status
level 3 is active, the lamp will light for 60 seconds after a motion
detection.
Status
Time
LEDs
Level 1
10 s
Level 2
30 s
Level 3
60 s
Level 4
120 s
Level 5
300 s
USER MANUAL 05
EN
FR