Vasco SYSTEM C Serie Manuel D'installation Et D'utilisation page 11

To comply with the ErP Ecodesign 2009/125/EC directive, at least one CO
MOUNTIN
RF switch or one RH RF switch must be installed.
G SWITCHES
Mounting tips:
Always place the switch away from places where moisture droplets may
form.Never place the wall transmitter in a metal housing or near large
metal objects.
MOUNTING RF SWITCH
Always mount the RF position switch in an easily accessible location.
1
2
3
4
Window
MOUNTING CO
Always mount the CO
room whose CO
supply voltage at the switch.
1
2
Loosen the knobs and electronics module to release the wall-mount
base plate.
Mark out screw holes from the base plate on the wall.
Mount the base plate to the wall with
screws.
Assemble in the following order:
Base 2
RF SWITCH
2
RF switch in an easily accessible location in the
2
concentration you wish to monitor. Always provide a 230V
2
Dismantle the switch.
Screw the base plate to the wall.
INSTALLATION MANUAL FOR THE INSTALLER 09
2
69,5
Electronics and buttons
EN
FR