Vasco SYSTEM C Serie Manuel D'installation Et D'utilisation page 14

SWITCHING ON AND OFF ADDITIONAL OPTIONAL CO RF SWITCH
2
Log on: Unplug the ventilation unit and reinsert it. After this, the ventilation unit
will search for new switches for 10 minutes. Then snap the sensor onto the
bottom plate to return it to power.
Touch the control area at the bottom right for a minimum of 3 seconds. When all
LEDs are flashing, release the control zone. If the header action is successful the
LED in the top left corner lights up 2x green and an LED will light up on the right
indicating the position of the CO RF switch. Tip: You can link one switch to a
2
maximum of 3 units. To do so, follow the actions above for each switch. When
connecting, make sure that only one ventilation unit is energised or that the other
units in the vicinity are energised for at least 15 minutes.
Logging off: Briefly de-energise the switch by clicking it off and back into the
base plate. The switch can disconnect ventilation units for 10 minutes. Touch
the control zone for at least 10 seconds.
bottom right. When all LEDs light green for the 2nd time, release the operating
zone. In case of multiple logged-in ventilation units, this will log off all logged-in
units. The switch's LED lights red 4x to indicate that the units have been de-
registered.
CONNECTING AND DISCONNECTING ADDITIONAL OPTIONAL RH RF SWITCH
Log on: Unplug the ventilation unit and reinsert it. After this, the ventilation unit will
search for new switches for 10 minutes. Then remove the batteries from the
sensor and replace them. (see replacing batteries RH RF switch).
Touch the control area at the bottom right for a minimum of 3 seconds. When all
LEDs are flashing, release the control area. If the header action is successful, the
LED in the top left corner lights up 2x green and an LED will light up on the right
indicating the position of the RH RF switch. Tip: You can link one switch to a
maximum of 3 units. To do so, follow the procedure above for each switch. When
pairing, make sure that only one ventilation unit is energised or that the other
units in the neighbourhood are energised for at least 15 minutes.
Logging off: Briefly de-energise the switch by removing the batteries from the
sensor and putting them back in (see Replacing batteries RH RF switch). The
switch can de-energise ventilation units for 10 minutes. Touch the control area
at the bottom right for a minimum of 10 seconds. When all LEDs light up for the
2nd time, release the operating zone. In the case of several ventilation units
being switched on, this will unlock all
logged-off units. The switch's LED lights red 4x to indicate that the units have
been disconnected.
12 INSTALLATION MANUAL FOR THE INSTALLER