Vasco SYSTEM C Serie Manuel D'installation Et D'utilisation page 12

B
E
C
10 INSTALLATION MANUAL FOR THE INSTALLER
3 Open the cover on the base plate to reveal the electrical
connections.
4 Connect the 230V power supply to the connectors.
5 Replace the cover on the switch.
Step
MONTAGE Motion sensor PIR
Always mount the motion sensor in a place where movement can be
detected easily. Always provide a 230V power supply at the switch.
1 Dismantle the switch.
2 Screw the base plate (A) onto the provided flush-mounting
box using the screws (F) provided
3 Connect the power cable (230V) to the motion sensor connectors (B)
by inserting it through the finishing panel (X).
4 Screw the motion sensor (B) to the base plate (A) using the screws (E)
provided.
5 Click the finishing panel (
A
F
X
ELECTRICAL CONNECTION Motion sensor PIR
The electrical diagram below shows the electrical connection
clarified. Both connections (N&L) are required for
The basic operation of the sensor. A maximum of
a 20W lamp can be switched. L
3Step
C) on the motion sensor (B).
4Step 5
N L
20W
Max
VMI-02MP03
H5V4 1823
T40
230VAC 50Hz 5mA IP21
N
N