Vasco SYSTEM C Serie Manuel D'installation Et D'utilisation page 15

A
5 1
B
4 2
C
3
A: Status LED
B: Mode LEDs
C: Touch Button
COMMISSIONING AND
ADJUSTMENT
100 m /h
MIN
Settings:
fan mode
Capacity [m³/h]
Pressure [Pa]
Voltage [V]
Power [W]
CONTROL SWITCHES
See page 2.
IMPLEMENTATION Motion sensor PIR
Log on: Briefly de-energise the ventilation unit by removing the plug from the
socket and replace it. After this, the ventilation unit will
search for new switches for 10 minutes. Connect the power cable of the motion
sensor. All LEDs will light up for 3 seconds. After 3 seconds, the status LED will
light up green. The green LED will light after 2 seconds
flashing when motion is detected. Now hold down the control zone for 10 seconds.
When the status LED flickers between green and red, you can release the control
panel. If the pairing was successful, the status LED will briefly flash green. If the
status LED briefly flashes red, the pairing was unsuccessful and the registration
process will have to be repeated.
If all aerial and electrical connections have been made, the plug may be
plugged in.
Setting the air capacity:
The flow rate in position HIGH can be set by means of the potentiometer.
The potentiometer is located on the PCB. The flow rate of position "HIGH"
can be set by rotating the potentiometer with a flat screwdriver. If it is turned
fully anti-clockwise, the ventilation unit is set to its minimum. When the it is
turned fully clockwise, the ventilation unit is set to its maximum. The
maximum of the unit corresponds to 400m³/h at 150Pa. The figure below
gives a guide value for setting the potentiometer.
200 m /h
3
300 m /h
3
400 m /h
C400
Basic RF
1 2
100 200
15 40
230 230
4,6 11,4
INSTALLATION MANUAL FOR THE
I N S T A L L E R
3
3
C400
Basic RF LE
3 1 2
400 100 200
150 15 40
230 230 230
58,8 4,8 11,6
FANBOX C400
Basic RF LE
3 1 2
400 100 200
150 15 40
230 230 230
60,3 4,8 11,6
13
EN
FR
3
400
150
230
60,3