Create Wind Helix Manuel D'instructions page 12

4. Insert the locking pin into the end of the suspension rod and raise the ball. Make sure the
locking pin is aligned with the grooves inside the ball and secure the set screw.
Advice: To make it easier to insert the wires into the bar, place some electrical tape around
the wires. This will help you keep them together as you insert them into the bar.
5. Loosen the mounting screws and washer from the top of the motor housing. Remove the
bar pins (if you haven't already). Insert the rosette through the bar.
6. Thread the cables through the bar and pull the excess cables from the top of the bar to
tighten them.
7. Place the bar inside the motor housing and insert the pins you removed earlier. Tighten
the set screws and washers.
8. Lower the canopy towards the motor housing.
W IRING CON N ECT IO N
Make the connection between the receiver wires and the fan motor wires following the color
indications. Make sure the connection is tight.
Take ground
L
N
M OU NT I N G T HE CE ILI NG ROSE
1. Lift the canopy onto the mounting bracket and align the loosened screws on the mounting
bracket with the holes in the canopy.
2. Turn the finial to adjust it. Reinsert the screws and secure them with a screwdriver.
3. Once you have the mounting bracket secured to the junction box you can proceed to hang
the fan.
4. Grip the fan firmly with both hands. Pass the bar through the opening in the mounting
bracket and allow the ball to rest on the mounting bracket.
5. Rotate the ball coupling until it lines up with the tab on the mounting bracket.
Advice: Another person should help you hold the ladder and hand you the fan once you have
climbed the ladder.
ENGLISH
12
Ground (green/yellow)
L input
(black)
Remote
control
receiver
Input N
(white)
DC L motor (gray)
DC L motor (pink)
DC L motor (red)