Create Wind Helix Manuel D'instructions page 11

C HO ICE OF MOU NTI NG T YPE
Traditional assembly
The traditional setup hangs from the ceiling
with a rod.
This fan can be installed on both a regular and vaulted ceiling, and can extend the hanging
length with the longer hanging rod (supplied). To install the hanger bar you will need the
following tools: a screwdriver, flat head screwdriver, adjustable pliers or wrench, stepladder,
wire cutters, and electrical tape.
SUSP E N SION BAR I NSTALL AT IO N
• If you want to extend the hanging length of your fan, remove the ball from the hanger rod
and use the additional extension rod (included).
• If you want to use the extension bar, follow the following instructions:.
1. To remove the ball from the suspension rod, loosen the set screw and remove the
cotter pins.
2. Lower the ball and remove the locking pin.
3. Take the ball out of the hanger bar and insert it into the longer hanger bar (the top of the
bar has a hole for the set screw; use this to secure the bar).
Angle mounting is recommended on sloped
or vaulted ceilings.
Barrette
lock
Angle mounting
Cabling
Floron
Extension bar
Trim
Cap screw
Throne of
fixation
ENGLISH
11