Getting Started - Sony DVP-S7700 Mode D'emploi

Getting Started

z
If you have a digital component such as a receiver
(amplifier) with a digital connector, DAT or MD
Connect the component via the DIGITAL OUT OPTICAL
or COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied).
When you play a DVD, set the items in "INITIAL SETUP
3" in the setup display as follows (page 38):
• DIGITAL OUT : ON
• DOLBY DIGITAL : D-PCM
• DTS : OFF.
p When using an optical digital connecting cord
Optical digital connecting cord
Take off the cap and plug in the optical digital connecting
cord.
CD/DVD player
OPTICAL
PCM/DTS/
DOLBY DIGITAL (AC-3)
DIGITAL OUT
p When using a coaxial digital connecting cord
Coaxial digital connecting cord
CD/DVD player
OPTICAL
PCM/DTS/
DOLBY DIGITAL (AC-3)
DIGITAL OUT
Notes
• Refer to the instructions supplied with the component
to be connected.
• You cannot make digital audio recordings of discs
recorded in DTS and Dolby Digital (AC-3) format
directly using an MD deck or DAT deck.
When you make the connections above, do not set
the items in "INITIAL SETUP 3" in the setup display
as follows:
• DOLBY DIGITAL : DOLBY DIGITAL
• DTS : ON.
If you set even one of them, a loud noise will
suddenly come out from the speakers, affecting
your ears or causing the speakers to be damaged.
US
8
(not supplied)
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
COAXIAL DIGITAL IN
OPTICAL
(not supplied)
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
COAXIAL DIGITAL IN
COAXIAL
z
If you have a digital component with a built-in DTS or
Dolby Digital (AC-3) decoder
Connect the component via the DIGITAL OUT OPTICAL
or COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied). For details on hookups
and settings, see page 32.