Create Wind Large Manuel D'instructions page 8

Carefully open the packaging and remove all the items included. Place them on a carpet or a big
piece of plastic to avoid any damage.
Check that all the items listed below have been included.
Mounting bracket
X3 Blades
1. ON/OFF button
2. Timer
3. Fan intensity control
4. Reverse function
5. Sound off button
6. Batteries (2 x AAA)
Controller pairing
1. Turn off the main light switch in the room where you have installed your fan for at least 10
seconds.
2. Turn the switch on and you will hear a beep, within 3 seconds, press and hold the on/off
button until you hear a beep.
3. If the pairing process is unsuccessful, repeat the above steps again after turning off the
wall switch for at least 1 minute.
E NGL I SH
8
PARTS LIST
Canopy Bar
REMOTE CONTROL
Extension bar
Motor
1
2
Screws
Remote control
& driver
3
4
5
6