Create Wind Large Manuel D'instructions page 13

B L A DE S AS SE MB LY
Align the holes on the blade holder with the holes on the blades and the motor body and screw
them in place, but don't tighten them until they are all placed and screwed in.
Tip: To save time, you can fit the washers on each screw prior to installing the blades.
1
Connect the single-pin plugs of the connections plate with the ones on the LED panel. The
LED panel is magnetized so it will be attached to the connections panel just by placing
them together.
Note: While installing or removing the LED plate, please keep the insulation pads intact
carefully. Turning the set screws over-tightly or fast will damage the insulation pads.
Screw the lamp shade back to the connections plate.
C H ECK TH E IN STALL AT I ON
• Check the correct operation of the ceiling fan, checking that no strange movement or misalign-
ment is observed in any part of the fan.
• In the event that some kind of hum / vibration can be seen, you can proceed to adjust the blades
with the shooting kit.
• This kit has self-adhesive weights and "u" shaped clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip to a differ-
ent blade or use the adhesive weights.
* Only for models with Wi-Fi
The CREATE app is available for both Android and iOS (search for the app on Google Play
or App Store or scan the QR code below). There may be additional costs depending on the
provider.
This device is used through your home network. As an essential requirement, you must have
a Wi-Fi network always connected to your 2.4 Gh router and the free CREATE application.
(Internet providers currently offer both 5Gh and 2.4Gh simultaneously.)
We recommend that you disconnect the appliance from the mains when you are away from
home to prevent it from accidentally starting up while you are away.
CONNECTION TO THE APP
2
E NGLI SH
13