Parkside PWSA 12 C3 Mode D'emploi page 39

5 . Press the spindle retaining tab and tighten the
clamping screw using the hex key . Release the
spindle retaining tab .
˜ Inserting/removing the
rechargeable battery
o Inserting the battery: Push the battery
along the guide rails into the product . The
battery clicks into place .
Removing the battery: Press the release
o
[ 8 ]
button on the battery and pull the battery
out .
˜ Operation
m
WARNING!
Wear protective gloves when changing
the tool so as to avoid injuries from cuts .
m
WARNING!
Switch the product off and remove
the battery pack before replacing
attachments, cleaning and when not in
use .
m
CAUTION! RISK OF INJURY!
u
Only use grinding discs and accessories
recommended by the manufacturer . Using
other attachment tools and other accessories
can represent a risk of injury for you .
u
Only use accessory parts which bear
information about the manufacturer, type
of connection, dimension and permitted
number of revolutions .
u
Only use accessory parts where the printed
rotational speed is at least as high as what
has been specified on the name plate of the
product .
u
Do not use any broken, cracked, or
otherwise damaged grinding discs .
u
Never operate the product without protective
equipment .
m
CAUTION! RISK OF INJURY!
u
Support the plates or workpieces in order to
reduce the risk of kickback from a jammed
cutting disc . Large workpieces may bend
under their own weight . The workpiece must
be supported on both sides of the disc, not
[ 9 ]
only near the cutting disc, but also at the
edge .
u
Keep your hands away from the disc when
the product is in operation . Risk of injury .
˜ Switching the product on/off
m
CAUTION! RISK OF INJURY!
u
The cutting/grinding disc still runs even after
the product has been switched off .
NOTE
u
After switching on the product, wait until the
product has reached its max . speed . Only
then should you start with the work .
Switching on: Push the pressure point on
o
the on/off switch
on/off switch
on and starts . To engage the product, push the
on/off switch forwards .
Switching off: Push down the pressure
o
point on the on/off switch
[ 5 ]
switch downwards . The product switches
off .
Trial run
Always carry out a trial run before carrying out
your first grinding procedure and after every disc
replacement . Switch the product off immediately
if the grinding disc is not rotating smoothly, if
considerable vibration occurs or if you hear
abnormal noises .
˜ Checking the battery charge
level
NOTE
u
The battery indicator
charge level of the battery
5a ] [
downwards and slide the
5 ] [
forwards . The product turns
5a ] [
to tilt the on/off
6 ] [
indicates the
9 ] [
.
GB/IE 39