Bosch GIC 12V-5-27 C Professional Notice Originale page 31

Fitting the mirror, magnet or hook (see figure E)
The mirror (29), the hook (28) or the magnet (27) can be fitted on the camera head (2)
as accessories.
Push one of the three accessories, as shown in the figure, all the way onto the camera
head (2).
Note: The magnet (27) and the hook (28) are only suitable for moving and removing
loose, small and light objects. The inspection camera or the accessory can be damaged
with too strong a pull.
Operation
Protect the handheld device and the rechargeable battery or battery adapter
u
from direct sunlight. Protect the rechargeable battery or battery adapter against
moisture. The camera cable (1) and camera head (2) are watertight if assembled cor-
rectly; the handheld device (13) is splash-proof. However, the rechargeable
battery (14) and the battery adapter are not protected against water. If they come
into contact with water, there is a risk of electric shock or damage.
Do not use the inspection camera if the lens on the camera head (2) has fogged
u
up. Switch the inspection camera on only if the moisture has evaporated. The in-
spection camera may otherwise become damaged.
The switched-on light (3) can become hot during operation. To avoid burns, do not
u
touch the light.
Do not subject the inspection camera to extreme temperatures or variations in
u
temperature. For example, do not leave it in a car for extended periods of time. In
case of large variations in temperature, allow the inspection camera to adjust to the
ambient temperature before putting it into operation.
Starting Operation
Switching On and Off
To switch on the inspection camera, press the ON/OFF button (6) or the centre
button (9).
Note: If the camera cable is not fitted when switching on, the display will show an error
message.
To switch off the inspection camera, press the ON/OFF button (6) until the display
switches off.
Bosch Power Tools
English | 31
1 609 92A 9RJ | (24.05.2024)