Flex LB 125 18.0-EC Notice D'instruction D'origine page 27

LBE 125 18.0-EC/LB 125 18.0-EC/L 125 18.0-EC-LD
Turn guard hood opposite to the

direction-of-rotation arrow on the gear
head to the required position.
Adjusting clamp-fit hood
Release clamping lever (1.).

Adjust clamp-fit hood (2.).

Tighten clamping lever again (3.).

NOTE
The protective hood must be held firmly to
prevent it from turning. If necessary, before
operating the clamping lever, tighten the
hexagon nut until the lever can just be
actuated by hand.
Work instructions
NOTE
When the power tool is switched off,
the grinding tool continues running briefly.
Rough-grinding
WARNING!
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING!
A special cutting guard must be used for
cutting.
See manufacturer's accessories catalogue.
– The angle grinder must always be
operated backwards.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of the
groove.
– Do not press, tilt or oscillate the power
tool.
– Adjust the feed to the material which is to
be cut: the harder the material, the slower
the feed.
For further information on the manufac-
turer's products go to www.flex-tools.com.
Maintenance and care
WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
Regularly clean the power tool and

ventilation slots. Frequency of cleaning is
dependent on the material and duration
of use.
Regularly blow out the housing interior

and motor with dry compressed air.
Regularly clean the filter cover.

27