Atag MC 4211 L Mode D'emploi page 101

Programming by power
Press the SELECT key to select the microwave
function. The maximum power level, 1000W,
flashes in the display.
Press the "-" key if you wish to set a lower
microwave power level, ex. 500W. Confirm the
power level by pressing ENTER, the time dig-
its flash in the display.
Press the "+" key to set the required pro-
gramme time, ex. 10 minutes.
Confirm by pressing START. The light switches
on and the programme starts.
You may press the "+" key directly to pro-
gramme microwave power level 1000W.
You may press the "-" key directly to select your
microwave power level. Then proceed as above.
Comments:
If the door is opened during cooking, the appliance stops and the remaining time
flashes in the display. To finish the programme, simply close the door and press
START .
The time can be adjusted at any time simply by pressing the - / + keys.
express programme
Express Programming
Press the START key for 1 second to set an
express programme of 30 seconds. The micro-
wave functions at maximum power level
(1000W). The light switches on and the pro-
gramme starts.
You may set an express programme up to 2 min 30 s.
Each time you press START an additional 30
seconds of programme time is added. Press 5
times for 2 min 30s.
heat & hold function
Heat & hold
If you leave your dish in the oven without opening
the door at the end of a microwave or express pro-
gramme, a heat and hold function starts up after 2
minutes to maintain the temperature of your dish.
A triple beep after 15 minutes announces the end
of the heat and hold programme.
using your appliance
microwave function
Display
Display
Display
101