Publicité
Les langues disponibles
Les langues disponibles
Using the Dual Mode Body Pads
c
Make sure Revitive is switched off. Plug the other end of the electrode cord
into the electrode pad port on the side of Revitive.
Plugging in the electrode cord will automatically turn the foot-pads off.
d
Remove the plastic liner from the electrode pads. Put the liner to one side as
you will re-use it after the session has ended.
e
Press the electrode pads on your chosen area, as shown on page 23 or the Thigh
Pads as shown on page 27, gently pressing the adhesive side against the skin.
f
Refer to page 20 which explains how to control the stimulation from the app.
The Body Pad Programs can be automatically selected as part of your suggested
Therapy Plan or manually, by tapping the Program name at the top of the
Controller screen when no stimulation is running.
Auto-pause will occur if a pad is disconnected from the body or a cable is
disconnected. Reconnecting and tapping
24
8035_IFU01_19037975_PRINT.indd 24-25
8035_IFU01_19037975_PRINT.indd 24-25
will re-start the stimulation.
Removing the electrode pads
a
Check Revitive is switched off after the session, then gently peel the electrode
pads from the skin.
Do not pull the electrode pads off the skin using the electrode cords as this may
damage the cords.
b
Replace the electrode pads onto their plastic liner after use.
c
Unplug the electrode cord from Revitive.
EN
25
08/03/2023 15:41
08/03/2023 15:41
Publicité
