SilverCrest SDB 2400 B3 Mode D'emploi page 23

Before first use
1) Remove the steam iron from the packaging .
2) Remove all stickers and protective films from
the steam iron .
WARNING – RISK OF
SUFFOCATION!
Plastic bags can be dangerous . To avoid the
risks of asphyxiation, keep plastic bags out of
the reach of babies and toddlers .
3) Fill the water tank with water (See the chapter
"Filling the water tank") .
4) Insert the plug into a mains power socket sup-
plying an electrical current as detailed on the
rating plate .
You will hear a beep, the display 1 switches
on and shows the word "STdby" (Standby) in
red letters . The appliance is now in standby
mode .
5) To switch on the iron and set the temperature,
press the TEMP
11/MAX appears on the display 1 .
6) Heat the steam iron up for several minutes at
the highest setting .
7) Activate the steam blast button 5 several times
so that steam comes out of the sole of the iron 0 .
8) Then iron over a piece of scrap fabric to re-
move any production residues that may remain
on the sole of the iron 0 .
9) Press the TEMP 2 button repeatedly until
the display 1 reads "STdby" (Standby) in red
letters .
10) Remove the power plug from the mains power
socket .
■ 20 │ GB │ IE
All manuals and user guides at all-guides.com
3 button repeatedly until
Automatic switch-off
This steam iron is fitted with an automatic switch-off
system . This stops the steam iron from heating up .
When the steam iron is resting on its sole 0 and
is not moved for approx . 30 seconds, 6 warning
beeps will sound while "PAUSE" appears in red in
the display 1 . The steam iron will stop heating up .
To deactivate the automatic switch-off, lift up the
steam iron and move it gently from side to side .
The previously set temperature level is shown again
in white and the steam iron heats up again .
When the steam iron is resting on its base 7and
is not moved for approx . 8 minutes, 6 warning
beeps will sound while "PAUSE" appears in red in
the display 1 . The steam iron will stop heating up .
To deactivate the automatic switch-off, lift up the
steam iron and move it gently from side to side .
The previously set temperature level is shown again
in white and the steam iron heats up again .
NOTE
The automatic switch-off is not intended as a
substitute for removing the plug from the mains
power!
It is merely designed to prevent the appliance
from overheating and helps to avoid unneces-
sary power consumption .
It does not provide fire protection, however, e .g .
if you place and leave the hot steam iron on
flammable material .
SDB 2400 B3