Sage the Bambino Plus BES500 Guide Rapide page 16

The machine will indicate that it requires
descaling when the 1 CUP and STEAM button
and the 2 CUP button flash alternately for
15 seconds. Pressing any of these buttons
will cancel the alert and return the machine
to ready mode.
WARNING
Do not immerse the power
cord, power plug or appliance
in water or any other liquid.
The water tank should never
be removed or completely
emptied during descaling.
TO DESCALE
NOTE
Ensure that the water filter is removed from
the water tank before adding the descaling
powder when descaling the machine
1. Empty the drip tray and re-insert into
position on the machine.
2. Fill the water tank to the DESCALE line
with hot tap water, and add and dissolve
the descaling agent by stirring gently.
3. Place a 2L / 68 fl.oz container under the
grouphead and steam wand.
4. Turn the machine off by simultaneously
pressing the 1 CUP and STEAM
buttons, and allow it to completely cool
before descaling.
16
5. With the machine off, press the 1 CUP
and STEAM buttons simultaneously for
5 seconds to enter descale mode.
6. The 1 CUP and STEAM buttons will
illuminate, indicating that the machine
is ready to start descaling.
7. Press the 1 CUP or STEAM
button to begin the descale cycle.
These buttons will alternately flash
throughout the cycle.
8. Once the descale solution has been
used up, the descale mode will pause.
Refill the water tank to the MAX line and
empty the waste water container, then
replace both parts on to the machine.
9. The 1 CUP and STEAM buttons will
illuminate when the machine is ready.
Press the 1 CUP or STEAM button to
resume descaling.
10. When descaling is complete, the 1CUP
and STEAM button will alternately
flash. The machine will then go into
standby mode.
11. Remove and empty the waste water
container. Rinse the drip tray and water
tank and dry thoroughly before replacing
them back onto the machine.
STEAM WAND BLOCKED
During milk texturing, if the machine detects that
the steam wand is blocked, it will immediately stop
operating and the STEAM button light will be off.