Publicité
Les langues disponibles
Les langues disponibles
I
EN
50
Programming with KESO k-entry
(separate instruction manual)
The KESO Integra Door Controller is programmed using the k-entry
management software in combination with the KESO K-Service via the Ethernet.
If the network fails, the KESO Integra Door Controller can also be programmed via
the KESO programming device V3.
With optional Door Monitoring license:
The KESO management software k-entry
used to configure a door monitoring system.
Note!
In order to evaluate this function, additional reed switches are needed at the
door for monitoring and evaluation. Evaluation or signalling can take place via a
motorised lock control system, for example.
Configuration
1
Select the header KEK.
2
Select Door monitoring (Tab. 1–
3
Then select «Configuration»
4
Select an option.
Door contact (Door)
«Active open (contact open when door is closed)» is also activated, the
contact will be evaluated inversely. Depending on the reed contact, this status
must be altered (normally closed or normally open contact).
Bolt contact (Bolt)
If the field «Active open (contact open when door is locked)» is also activated,
the contact will be evaluated inversely. Depending on the reed contact, this
status must be altered (normally closed or normally open contact).
Indicator status in the KESO management software k-entry
· Green: door closed and locked
· Yellow: door closed but not locked
· Red: door open
®
®
(Properties – KEK header) can also be
6
)
2
.
3
: Is the door in a closed or open state? If the field
4
: Is the door locked?
®
KESO
®
Publicité
