Parkside PTBMOD 710 C3 Traduction Des Instructions D'origine page 36

GB MT
Replacement parts/Accessories
Spare parts and accessories can be obtained at
If you have issues ordering, please use the contact form. If you have any other questions,
contact the "Service-Center" (see page 35).
Position Position
Manual drawing
7 57-59
Troubleshooting
Problem
Device doesn't
start
Strong vibrations
36
www.grizzlytools.shop
Description
Parallel guide
Possible Cause
No mains voltage
Main circuit breaker is
tripped
On switch (3) / off
switch (2) defective
Defective motor
Motor unit (1) not fixed
in place
Bit not centred in the drill
chuck
Error correction
Check the socket, mains supply cable,
cord, mains plug; if necessary, have
them repaired by a qualified electrician.
Check the main fuse
Repair by Customer Service
Repair by Customer Service
Tighten the clamping lever (10)
Tighten the short grub screw (25)
Check the bit in the drill chuck (17)
Ordernumber
91110375