Publicité
Les langues disponibles
Les langues disponibles
GB
MT
Switching on
1. Press the On switch (3).
Switching off
1. Press the Off switch (2).
Drilling
1. Switch the tool on.
2. Turn the lifting wheel (14) anticlockwi-
se.
3. The drill chuck (17) is lowered.
4. Drill into the work-piece at the appropri-
ate feed rate and to the desired depth.
5. Be aware of any necessary chip brea-
king on the way to the desired depth.
6. Move the bit slowly back to the stop
position.
7. Switch the tool off again.
General Information
The feed rate and spindle speed are
decisive for the service life of the bit.
-
The cutting speed is determined by the
speed of the drill spindle and by the
diameter of the bit.
-
In principle, therefore, the larger the
bit diameter, the lower the speed that
should be selected.
-
For workpieces of greater strength, the
cutting pressure must be higher.
-
Repeated withdrawal of the bit enables
easier chip removal.
-
Chip removal is especially difficult in
deep holes. Reduce the feed rate and
speed in this case.
-
To avoid excessive wear on the cutting
surface of the bit, for drill holes over
8.0 mm in diameter you should first
drill with a bit with a smaller diameter.
-
For wide and long work-pieces, ensu-
re sufficient support, such as with a
sawhorse. Otherwise work-pieces that
32
extend past the baseplate could tip and
damage the tool or the bit.
Removing Blockages
-
You should always select a suitable
feed rate which allows trouble-free chip
breaking.
-
If the bit is jammed in the workpiece,
turn off the power and unplug the po-
wer cord. Turn the bit on the drill chuck
anticlockwise with a little jerk to break
the chip and release the bit again.
-
If a fragment is produced during the
processing of the workpiece, turn off
the power and unplug the power cord.
Use a pair of pliers and remove the
fragment to prevent it flying off in an
uncontrolled way.
Cleaning and
maintenance
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this
instruction guide performed by
a professional. Only use original
parts. Allow the device to cool
off before any maintenance or
cleaning is undertaken. There is a
risk of burning!
Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Exchange the dama-
ged parts.
Original spare parts are available
from our online shop, see the chap-
ter "Spare parts/Accessories".
Publicité
