5.5
Filling the water tank
If you want to use the misting function
Mist 21, fill water into the water
tank 13.
You can also use the device 10 without wa-
ter. It then operates as a fan without the de-
scribed cooling effect.
1. Pull the water tank 13 out of the de-
vice 10.
2. Remove the lid 15 from the water
tank 13.
3. Fill the water tank 13 no higher than
the MAX marking (450 ml) next to the
viewing window 12. Use cold, fresh
tap water without additives.
NOTE: to increase the cooling effect, you can
cool the tap water in the refrigerator before-
hand.
Figure B: the water tank 13 can also be
filled with ice cubes in the outer section - for
better cooling.
4. Put the lid 15 back on the water
tank 13.
5. Dry the outside of the water tank 13.
6. Push the water tank 13 back into the
device 10. It clicks audibly.
Filling the water tank 13 to the MAX mark-
ing is sufficient for approx. 6 hours of oper-
ation with the misting function
When the water is used up, the device re-
minds you to refill it by the LED 4 flashing
red and sounding an acoustic signal. The
device continues to run without the misting
function.
5.6
• Press the on/off switch
for approx. 1 second to switch the de-
vice 10 on.
- An acoustic signal sounds.
- The fan starts at a low speed. The 1
• Press the on/off switch
again for approx. 1 second to switch the
device 10 off again. An acoustic signal
sounds.
• After each use, unplug the power supply
unit 7, and empty and clean the water
tank 13 if necessary.
5.7
•
With the device switched on, press the
speed control
times in succession to switch between
the 3 speed settings:
Display 17
An acoustic signal sounds each time the
button is pressed.
Mist 21.
•
Figure C: you can influence the direc-
tion of the air flow by tilting the front
protective grid 3 on the handle 1 up-
wards or downwards.
Switching the device on/
off
on the display 17 lights up.
Regulating the air flow
Speed 19 several
Speed
1
2
3
Evaporation volume: 70 ml/h
Power 18
Power 18
Speed
low
medium
high
27
GB