SilverCrest STLKS 10 A1 Mode D'emploi page 30

5.8 Swivel function
Figure D: the device has a swivel function.
It causes the device to swivel back and forth,
thus distributing the flowing air more evenly
in the room.
• With the device switched on, switch on
the swivel function by pressing the
Swing 20 button. An acoustic sig-
nal sounds. The fan starts to swivel
back and forth.
• Switch the swivel function off by press-
ing the Swing 20 button again.
An acoustic signal sounds.
5.9 Misting function
With the misting function, water from the
water tank 13 is finely misted and directed
through the mist outlet 2. In this way, the air
in the air flow is humidified.
NOTES:
• To enjoy the fresh mist spray as quickly
as possible, fill the water tank 13 to the
MAX marking. If the water tank 13 is
only half full, it takes a little longer for
the mist spray to come out.
• Always make sure to clean the water
tank 13 after 3 days at the latest and
always use fresh tap water. If there is a
bad or musty smell, be sure to clean the
water tank.
• With the device switched on, press the
Mist 21 button to switch on the
function. An acoustic signal sounds.
• Press the Mist 21 button to switch
the function off again. An acoustic sig-
nal sounds.
• The LED 4 flashes red and/or acoustic
signals sound if there is no water in the
water tank 13 or the water tank has
been removed. Fill up the water and
push the water tank into the device.
28 GB
Press the Mist 21 button again to
restart the function.
5.10 Switching on the light
and selecting the colour
1. Switching on: press the light and colour
selector switch
switch on the mood light in colour
change mode. You will see smooth
transitions of all available colours until
it is switched off.
2. By pressing the light and colour selec-
tor switch Light 22 again, while
the colour change mode is active, you
can select one of seven colours (press
the light and colour selector switch
Light 22 again for each colour).
This is then permanently displayed.
If no colour appears after pressing the
light and colour selector switch
Light 22, the light/colour display
is switched off again.
3. Press the light and colour selector
switch Light 22 again to switch the
mood light back on in colour change
mode.
An acoustic signal sounds each time the but-
ton is pressed.
5.11 Timer function
With the timer function, you can set a time
after which the fan automatically switches
off. You can set a time between 1 and
6 hours in 1-hour increments.
• With the device switched on, press the
Timer 23 button repeatedly. 1 hour
is added each time the button is
pressed. The lit LEDs of the display 16
show the set time. Add up the times of
the lit LEDs to get the set time:
- 1 H: 1 hour
- 2 H: 2 hours
- 3 H: 3 hours
Light 22 once to