SilverCrest STLKS 10 A1 Mode D'emploi page 28

5. Operation
5.1 Transporting the device
• Above the rear protective grid 6 (on the
rear of the device) there is a recess for
carrying 5 the device.
• When the water tank 13 is full, take
care when moving the device 10.
5.2 Setting up the device
• Place the desktop air cooler 10 on a flat
surface where the device is secure and
cannot be accidentally knocked over.
• Choose a place...
... with sufficient clearance around the
device 10.
... at table height (e.g. on a desk or
chest of drawers) for optimum air cir-
culation.
... near the place you want cooled.
NOTE: When selecting the location, please
note that the connected device will remind
you via acoustic signals to change the water
after up to 72 hours. These acoustic signals
occur regardless of the time of day.
5.3 Connect the device to
the mains
The first time and every time it is re-
connected to the mains power sup-
ply:
1. Insert the plug into the wall socket:
- the LED 4 flashes red
- several acoustic signals can be
heard
2. Pull out the water tank 13.
3. Fill the water tank with fresh tap water
or clean it.
26 GB
4. Push the water tank back into the de-
vice.
This function reminds you to fill the water
tank 13 with fresh tap water. It also reminds
you to clean the water tank at least every 72
hours.
5.4 Connecting the device
1. Plug the power supply unit 7 into a
properly installed, easily accessible
mains socket whose voltage corre-
sponds to that specified on the rating
plate. The wall socket must still be easi-
ly accessible after connection.
2. Insert the USB-C plug 8 into the USB-C
port 9 on the back of the device 10.
The LED 4 flashes red and several acoustic
signals sound. This is a reminder that the wa-
ter tank 13 must be cleaned at least every
72 hours and filled with fresh tap water be-
fore each use. When you reinsert the water
tank afterwards, the LED stops flashing.