SilverCrest STLKS 10 A1 Mode D'emploi page 32

4. Pull the filter upwards out of the filter
holder 14 and dispose of it.
5. Place the new filter in the filter hold-
er 14.
6. Place the filter holder 14 under the
lid 15 from below and turn it (as
shown) until it is firmly seated.
7. Put the lid 15 back on the water
tank 13.
8. Push the water tank 13 back into the
device 10. It clicks audibly.
30 GB
6.3 Housing
1. Clean the housing from time to time
with a damp cloth using a small
amount of detergent.
2. Dry with a soft cloth.
7. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
Do not attempt to repair the device your-
self under any circumstances.
Possible causes/
Problem
Troubleshooting
No - Has the device been con-
function nected to the power sup-
ply?
- Check the connection.
Bad, musty - Clean the water tank 13.
smell - Always use fresh tap wa-
ter.
The LED 4 - Was the device discon-
flashes red nected from the mains
and power supply? Proceed as
acoustic described in chapter "Con-
signals nect the device to the
sound. mains".
No misting - Is the filter inserted?
function. Insert the filter.