Publicité
Les langues disponibles
Les langues disponibles
15. Disposal and recycling
The device is supplied in packaging to avoid transport damages. This packaging is raw material and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of different materials, such as metal and plastic. Take defective components to special waste disposal
sites. Check with your specialist dealer or municipal administration!
The packaging is wholly composed of environmentally-friendly materials that can be disposed of at a local recycling
centre.
Contact your local refuse disposal authority for more details of how to dispose of your worn-out electrical devices.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the Directive (2012/19/
EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be handed over at the intended collection point.
This can be done, for example, by returning it when purchasing a similar product or delivering it to an authorised collection point for the
recycling of old electrical and electronic devices. Improper handling of waste equipment may have negative consequences for the
environment and human health due to potentially hazardous substances that are often contained in electrical and electronic equipment. By
properly disposing of this product, you are also contributing to the effective use of natural resources. You can obtain information on collection
points for waste equipment from your municipal administration, public waste disposal authority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste disposal company.
16. Troubleshooting
WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Possible cause
Saw blade without pins
Saw blade clamping screw (28/29) not tightened
loosens after switching off
enough
the engine
Motor does not start
Mains fuse blown
Extension cable defective
Fine-wire fuse defective
Connection to the motor or switch not OK
Motor or switch faulty
Saw blades brake
Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Saw blade oscillates, not
Holders not aligned
aligned straightly.
Remedy
Tighten the saw blade clamping screw (28/29)
Check mains fuse
Replace the extension cable
Check the fine-wire fuse and, if necessary, replace it with
a fine-wire fuse of the same type.
Have this checked by an electrician
Have this checked by an electrician
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders. Bring the hold-
ers into the vertical position and tighten the screws again.
GB/IE
11
Publicité
