Before First Use; During Use - Reely Earthquake Notice D'emploi

b) Before first use
• Select a suitable location to fly the helicopter.
• When switching the helicopter on, always follow the procedures outlined in the separate section of these
instructions. This ensures that the remote control and receiver connect properly and that the model
responds reliably to remote control commands.
• Ensure that there are no other models operating on the same frequency (2.4 GHz) within range of the
remote control. Always check whether there are any other 2.4 GHz remote control systems that may
interfere with the model.
• Conduct regular checks to verify that the model and remote control are safe to use. Inspect the parts
for any signs of damage, such as broken connectors or damaged cables. All moving parts on the model
should move freely, but there must be not any slackness in the bearing.
• The helicopter battery must be charged before use. Make sure that the batteries in the remote control
have sufficient capacity remaining (use a battery tester). If the batteries are empty, replace all of the
batteries at the same time. Never replace individual batteries.
c) During use
• Do not take any risks when using the product! Always use the model responsibly, otherwise you may
endanger yourself and your surroundings.
• Improper use can cause serious injury and damage to property! Ensure that you maintain a sufficient
distance from people, animals and objects.
• Never attempt to touch the helicopter during a flight. Keep your body and hair away from rotating parts
such as rotors and gear wheels.
• O nly fly the model when you are fully alert and able to respond. Fatigue, alcohol and medication can
affect your ability to respond.
• Do not fly the model towards spectators or towards yourself.
• The motors, motor controller and helicopter battery may become hot during use. For this reason, allow
the helicopter to cool down for 5-10 minutes before charging or replacing the helicopter battery.
• Always leave the remote control (transmitter) switched on when the model is in use. After landing, always
switch off the helicopter first before you switch off the remote control.
• Never switch the remote control off when the helicopter is switched on.
• Do not expose the model or the remote control to direct sunlight or excessive heat for prolonged periods.
• In the event of a severe crash (e.g. from a high altitude), the electronic gyro sensors may be damaged.
Always check that the model is functioning properly before flying it again!
• In the event of a crash, switch off the rotor motors immediately. Rotating rotors may be damaged if they
come into contact with obstacles or in the event of an impact. Check the rotors for any signs of cracks or
damage before flying the model again!
• To avoid damaging the model due to a crash caused by an undervoltage/overdischarging of the battery,
monitor the undervoltage indicators during the flight.
28