Publicité
Les langues disponibles
Les langues disponibles
Connecting to the App
1. Download App
Search for "Roborock" in the App Store or
Google Play or scan the QR code to download
and install the app.
2. Reset WiFi
a. Open the top cover and find the WiFi
indicator light.
b. Press and hold the
and
until you hear the "Resetting WiFi" voice
message. The reset is complete when the
WiFi indicator light flashes slowly. The
robot will then wait for a connection.
Note:
If you cannot connect to the robot due to your
router configuration, a forgotten password, or any other
reason, reset the WiFi and add your robot as a new device.
3. Add Device
Open the Roborock app, tap the "Scan to
Connect" or "Search for Device" button and
add your device as instructed in the app.
Notes:
• The actual process may vary due to ongoing app updates.
Follow the guide provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 30 minutes for a connection,
WiFi will be automatically disabled. If you want to
reconnect, reset the WiFi before proceeding.
Instructions for Use
C
On/Off
Press and hold the
robot. The power indicator light will turn on
and the robot will enter standby mode.
Press and hold the
robot and complete the cleaning cycle.
Note:
The robot cannot be turned off when it is being charged.
Filling the Water Tank
C1
buttons
Remove and open the clean water tank and
fill the tank with water to MAX. Close the lid,
lock the latch, and fit the tank back in place.
Notes:
• To prevent corrosion or damage, do not use any disinfectant
and only use cleaning solution recommended by Roborock
in the water tank.
• Do not add too much cleaning solution to prevent the
robot from working improperly due to slipping.
• To avoid water tank deformation, do not place hot water
in the tank.
• If water marks remain on the water tank, wipe them
clean before reinstallation.
Starting Cleaning
C2
Press the
button to turn on the
button to turn off the
button to start cleaning. The
09
robot will plan its cleaning route according
to its scan of the room. It splits a room
into zones, first draws out zone edges, and
then fills the zone in a zigzag pattern. In
so doing, the robot cleans all zones one by
one, efficiently cleaning the house.
C2-1—Zone 1 – Cleaned.
C2-2—Zone 2 – Cleaned.
C2-3—Zone 3 – In Progress.
C2-4—Zone 4 – Next Zone.
Notes:
• To allow the robot to automatically vacuum and return
to the dock, start the robot from the dock. Do not move
the dock during cleaning.
• Cleaning cannot start if the battery level is too low.
Allow the robot to charge before starting the cleanup.
• Before cleaning, tidy cords (including the power cord
of the dock) and valuables from the floor. Loose
items may be dragged by the robot, resulting in the
disconnection of electrical appliances or damage of
cords and property.
• If cleaning is completed in less than 10 minutes, the
area will be cleaned twice.
• If the battery runs low during a cleaning cycle, the robot
will automatically return to the dock. After charging,
the robot will resume where it left off.
• The robot will retract mop cloth mounts when cleaning
the carpet. You can also set the carpet as a no-go
zone in the app to avoid it.
• Before starting each cleaning task, make sure that the
mop cloths have been properly installed.
Spot Cleaning
Press and hold the
button to start spot
cleaning in pause mode.
Cleaning range: The robot cleans a 1.5 m (4.9 ft) x
1.5 m (4.9 ft) square area centered on itself.
Publicité
