Roborock Qrevo Pro Mode D'emploi page 12

Note: A dirty mop cloth will affect the washing performance.
Clean it before use.
D7-2—Stick the mop cloth on the mount in
position and firmly.
Robot Sensors
D8
* Clean as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
D8-1—Dock Locator
D8-2—Reactive Tech Obstacle Avoidance Sensor
D8-3—Wall Sensor
D8-4—Communication Sensor
D8-5—The Carpet Sensor
D8-6—Four Cliff Sensors
Moving Dock
D9
Lift up and move the dock. Do not move the
dock by lifting the dock base, water tank handles
or dust container cover directly to prevent
the dock from falling off.
Dirty Water Tank
D10
* Clean as required.
Open the dirty water tank lid and pour out
the dirty water. Fill the tank with clean water,
close the lid, and shake. Pour out the dirty
water. Close the lid and then re-install.
Charging Contact Areas
D11
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the robot and the dock.
Replacing Disposable Dust Bag
D12
* Replace as required.
D12-1—Remove the dust container cover.
D12-2—Remove the disposable dust bag in the
direction of the arrow and discard it.
Notes:
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before closing the dust
container cover to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
D12-3—Clean around the filter with a dry
cloth. Install a new disposable dust
bag in place along the slot and
unfold the dust bag to maximize
emptying performance.
Note: Make sure the disposable dust bag is properly
sealed to avoid waste escaping and damaging the dock.
D12-4—Close the dust container cover and
make sure it is securely sealed.
Cleaning Tank
D13
* Clean as required.
D13-1—Remove the cleaning tank.
D13-2—Rinse the cleaning tank and the filter
with water.
D13-3—Reinstall the cleaning tank.
12
Basic Parameters
Robot
Model QR1PES
14.4 V/5200 mAh (TYP)
Battery
lithium-ion battery
Rated Input 20VDC 1.5A
Charging Time Approx. 4 hours
Note: The serial number is on a sticker on the underside
of the robot.
Empty Wash Fill Dock
Model EWFD16HRR
Rated Input Voltage 220-240VAC
Rated Frequency 50-60Hz
Rated Input (Dust
3A
collection)
Rated Input
(Hot water washing 5.6A
mop)
Rated Input
0.6A
(Charging & drying)
Rated Output 20VDC 1.5A
14.4 V/5200 mAh (TYP)
Charging Battery
lithium-ion battery