Publicité
Les langues disponibles
Les langues disponibles
Compensation curve and curve offset
Press the button
be modified with the DHW buttons
Adjust the required curve from 1 to 10 according to the characteristic (fig. 12).
By setting the curve to 0, sliding temperature adjustment is disabled.
Press the heating buttons
the DHW buttons
Press the button
If the room temperature is lower than the required value, it is advisable to set a higher order curve and vice versa. Pro-
ceed by increasing or decreasing in steps of one and check the result in the room.
10
ECONCEPT 51/51i - 101/101i
(detail 8 - fig. 1) for 5 seconds, to display the actual compensation curve (fig. 10) which can
(details 1 and 2 - fig. 1).
I
fig. 10 - Compensation curve
(details 3 and 4 - fig. 1) to access parallel curve offset (fig. 13), modifiable with
(details 1 and 2 - fig. 1).
fig. 11 - Parallel curve offset
(detail 8 - fig. 1) again for 5 seconds to exit parallel curve adjustment mode.
90
10
85
80
70
60
50
40
30
20
20
10
fig. 12 - Compensation curves
cod. 3540N680 - 06/2008 (Rev. 00)
9
8
7
6
5
4
3
2
1
0
-10
-20
EN
Publicité
