Turning On - Rohde ST 630 Notice D'utilisation

5. Turning On

When turned on the controller performs a display test by lighting all
ST 630
display segments and illuminating all front panel indicator lamps.
The controller will sound a short beep.
The version number of the software embedded within the controller
F1.00
is now displayed. If you need technical support, you might be asked
for this code together with the serial number.
Next displayed is the thermocouple type setting. This should match
T/C: R
the type of thermo-couple fitted to the kiln and can be R, S, K or N
type.
The final display will show the kiln temperature. All other lamps should
20°C
be off.
If pressing any key causes LOCKED to appear then the keyboard has
LOCKED
been locked. This is an anti-tamper feature. Press the
down for 5 seconds to unlock.
This now shows that the keyboard is UNLOCKED. To re-lock the
UNLOCKED
keyboard, press the
If any mimic panel lamps are on, then the ST 630 is firing. To stop the firing press
the j key.
During firing the right-hand decimal point will light to show when
32°C
heating power is being applied to the kiln.
Segment Segment
Note: During power up of the controller, the SEGMENT display
°C °F
shows the set temperature units °C or °F.
24
key together and hold down for 5 seconds.
<
key and hold
<