SPIDO PC 300 Notice D'utilisation page 16

Safety information
 This pump is not equipped with a switch. For a permanent installation,
it is better to connect the pump with an electric switch
 Do not use the pump without a residual-current device (30mA)
 When the pump is running, there must be no particles in the water
(clean water only).
 Make sure that air can circulate easily around the pump, in order to
ensure its cooling, and make sure there is no risk of condensing
 Do not use the pump if safety devices are damaged or used. Never
deactivate safety devices.
 The pump must be used with 220-240 V AC current, as indicated on
the rating plate.
 Do not use the power cable for carrying the pump or for unplugging.
 Make sure that electric connections are protected from humidity.
 Avoid dry-running of the pump. Never use the pump if suction hose is
obstructed. Use a device for lack of water detection.
 It is strictly forbidden to pump corrosive, easily combustible, aggressive
or explosive liquids (such as gasoline, petroleum or nitro thinner),
saltwater and food.
 The temperature of the liquid must not exceed 35°C.
IMPORTANT : For your safety, read the
instructions
5