Publicité
Les langues disponibles
Les langues disponibles
5.2 First run – SET90
Turn the knob as far to the left as possible: the locomotive stops.
Press the key "A" repeatedly until address "0003" is shown in
the display.
Set the direction switch of the LH90 to the up position.
Turn the rotary
control-knob to the
right. The locomotive
speeds up.
Flick the direction-switch downwards through the centre
position. This will change the direction of motion of the
locomotive from forwards to backwards.
If you flick the direction-switch to the centre position, the
locomotive will stop with the amount of delay in braking which
is set in the locomotive decoder. If you afterwards flick the
switch in a different direction, the locomotive will speed up
again, also with the amount of delay that is set in the decoder.
In order to switch on the light function of the locomotive
decoder, press key "0
the light on, press it again and you will turn it off.
With this key you trigger an emergency stop, the locomotive
stops immediately.
M
". Press the key once and you will turn
Turn the rotary
control-knob
to
the
left.
The
locomotive slows
down.
17
E
Publicité
