R&G LP0254BK Instructions De Montage page 15

• Remove the tail unit. Pull the remaining half the wire through from the connector side
(picture 14).
Fill the 3 exposed holes with the 3x M8 bolts (item 8).
•
Refit the small L bracket and mudguard (picture 38 & 40).
•
Page | 15
Standard fitting procedure
Refit the taillight and reconnect the tail light connector.
•
Refit the air intake and air intake cover panel.
•
Refit the seat as original and licence plate (it may require drilling).
•
• Please check the operation of all lights before riding the motorcycle.
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR
•
DOWN ON THE LICENCE PLATE HANGER, THERE IS A SMALL CHANCE OF THE
LICENCE PLATE HITTING THE BACK WHEEL UNDER HEAVY LOAD AND OVER
LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK FOR THIS
POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK THIS COULD
RESULT IN SERIOUS INJURY.
Depending on local laws, attach enclosed reflector (item 23) in an appropriate location
•
• Retest the license plate illuminator and all lights before riding.
Digital copies of these instructions are available to download from
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other
services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is
responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G
shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or
maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident
or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for
indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service
concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of
R&G. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 2
CONSUMER NOTICE
R&G RETURNS POLICY (NON-FAULTY GOODS)
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
27/09/2021 (NSY)
R&G
www.rg-racing.com Email:
LP0254
www.rg-racing.com
info@rg-racing.com