Operating Instructions - Switching off and Storage
Switching Off
1. Close the tap from water supply securely and disconnect the water supply hose from the pressure washer.
2. Empty water from pressure washer by squeezing spray gun trigger while the motor is run for a few seconds to
eliminate remaining pressure from high pressure hose.
3. Turn OFF main power switch («0» position).
4. Remove the plug from the power outlet.
5. Rewind the power supply cord. Place in rear storage compartment.
6. Wait for the high pressure cleaner to cool down.
CAUTION
After use, let pressure washer cool down.
• Ensure the pressure washer is on level ground and not at risk of falling over.
• The pressure washer should not be in contact with flammable materials, or in their immediate vicinity.
Storage
• Wind up the high-pressure hose using the hose reel. Avoid bending or kinking hose.
• Wind up the electric power supply cable. Place in rear storage compartment.
• Store the pressure washer in a clean and dry place. Ensure the power supply cord and high pressure hose are
not damaged.
• Store in area that will not freeze.
Operating instructions / Routine Maintenance
Routine Maintenance and Cleaning
Follow the instructions in the "Switching off " section follow. Routine maintenance recommendations outlined in the table below.
MAINTENANCE
ACTION
INTERVALS
Before each
• Check the power supply cord, high-pressure hose, couplings, spraying
use
gun, wand. If any of these parts appear to be damaged, do not use
the pressure washer and contact an authorized technician.
Weekly
• Cleaning water inlet screen fi lter.
Remove the water inlet fitting (a) and remove the filter (b). Clean filter
under running water or with burst of compressed air. For tougher dirt,
use a product for removing lime scale or replace the filter. Contact an
authorized service centre to make sure you get the right spare part.
Replace the filter and secure the quick coupler fi tting back into
position.
Monthly
• Cleaning the nozzle.
Use the cleaning pin. Insert pin into nozzle spray hole to clear any
calcium build up or dirt particles.
16