Publicité
Operating instructions - Start up procedure
Steps to Getting Started
1. Ensure main power switch is OFF («0» position).
2. Insert electrical plug into the power outlet.
3. Unroll and attach the high pressure hose to the pressure washer pump.
4. Check that high pressure hose is connected to the spray gun, wand and the pump outlet.
5. Attach water supply inlet using quick connector with normal garden hose.
6. Open the tap on the water supply - ENSURE that water flows through the pressure washer. Squeeze the trigger on the
spray gun, let water flow through the system until it trickles out of the nozzle. Hold trigger for 20 seconds to ensure
constant flow of water and that water is not leaking or dripping from hose or coupler connections.
7. The pressure washer is ready to be powered ON - (Push the main switch to position «1»).
Using Pressure Washer
1. AVOID squeezing the spray gun trigger ON and OFF. Squeeze
the trigger continuously, use long and continuous spraying
technique when cleaning.
2. Moving and transporting
The top transport handle should only be used to move the
pressure washer from one location to another using the wheels.
WARNING
• NEVER use top carry handle to lift the machine.
• ONLY the lifting handle should be used to pick up the pressure washer.
• NEVER start a pressure washer without water being connected to the pump.
• ALWAYS check that high pressure hose couplers are connected to spray gun and pump.
• VERIFY that electrical cord and high pressure hose are not cut or damaged.
• Starting the motor without all the hoses connected and without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this instruction will void warranty.
Operating instructions - Use of detergent wand and bottle
• Ensure main power switch is OFF («0» position).
• Fill the bottle with the desired detergent
• Insert foam wand into detergent bottle.
• Connect wand with spray gun.
• Start up the pressure washer again, by putting the main switch
to position «1».
• Suction and mixing will start automatically when water flows
through.
Applying detergent
• Use long, even, overlapping strokes.
• Allow detergent to «soak in» (5 minutes) before washing and
rinsing.
• Reapply as required - prevent surface from drying.
Top carry handle
WARNING
• DO NOT allow detergent to dry on the surface being
cleaned .
• You must flush the detergent from the bottle and wand
system after each use. Simply remove the bottle and
wand then rinse in a sink or using a garden hose.
WARNING
• Use of chemical cleaners can cause bodily harm and/or
property damage.
• NEVER use liquids, that contain solvents, like petroleum
distillates or acetone or products that are highly
flammable, explosive and toxic when nebulized.
• Use ONLY pressure washer safe detergents/soaps.
Always carefully read and follow manufacturer labels
and instructions.
15
Lifting handle
Publicité
